Tired of manual cueing? I have the solution. Made from solid stainless steel and polished to match the chrome arm. These lifts are a nice fit and grub screw onto the armbase. I supply a Jelco lift which matches nicely. Armclip from Audio Technica.

This one features Delrin damper insert. Clear lacquered to prevent tarnishing. USA bound for this one.

The original lateral weight support rod was sheared off from a customers tonearm. I fabricate a very thin walled sleeve with new rod that pushes on and can be hobby glued in place. USA for this one.

Turned from solid brass. Double grub screws and lacquered to match the originals.

SME Whitworth threaded screw on counterweight. Extra heavy to balance SPU bodied cartridge. Fine hairline/brushed stainless steel finish.

Delrin damped Alphason heavy counterweight. Polished Stainless steel

Complete with light and heavy antiskate weights. Made to original dimensions and fit.

Motor stand for a Platine Verdier Turntable. This was shipped to Hong Kong

Feet / supports in ebony. These were shipped to Hong Kong

This featured ebony cores set into the gun metal. Solid ebony base. Circa 1.6kgs This was shipped to Hong Kong

Can be made to any thickness. Usual thicknesses 3/6/9mm. Solid Ebony.

Circa 400g

I recently made 2 of these. A AT16 and AT1503. Solid Stainless Steel. Both these required an extra spacer piece I made for the Jelco armift curved piece.

Made to your specification

Circa 800g. Weighed with a lead insert.

Finished in Satin Black Lacquer with a nylon tipped grub screw

Shown here fitted on the customer's gorgeous tonearm

Made to original dimension and weight specification.

Dampens unwanted tonearm vibrations

Further to the anti-skate mechanism, the lateral weight supporting shaft had sheared off. The thread left in the socket was not possible to remove. I made a new one piece thin sleeve that slides over the existing housing and shaft complete. Also a new lateral weight to match. Good as new.

I made an entire replacement anti-skate mechanism for this Fidelity Research FR64s tonearm, for a customer in New York. This involved determining the rare thread used for the pivot bolt and recreating the exact look and function of the original.

Fitting / adapter rings for mounting a large Altec horn to Vitavox S2 and Philips drivers

Fitting / adapter rings for mounting a large Altec horn to Vitavox S2 and Philips drivers. Show here with test bolts

Made to exact spec and finish of the original

complete with Nylon tipped grub screw

Normal weight counterweight for Fidelity Research FR64S tonearm. Complete with nylon damping insert. Brushed finish to match original arm.

Lateral weight for Fidelity Research FR64S tonearm. To identical spec as original

Shown here is the heavier one. I also make the lighter cartridge / headshell version